FOCUS Enhancements 3.2 Manual de usuario descargar pdf (Pagina 178)

Troubleshooting

164

Smooth Transitions

For smoother transitions, MPEG files in the same playlist should

be encoded at the same resolution and size (height x width).

SMPTE time codes are not recognized properly

Some SMPTE tracks loose information during compression and

may not "trigger" events as required. It is recommended to encode

these tracks "hot"--adding approximately +6 db to the track while

encoding. Again, testing is essential to account for variances in

encoders and SMPTE devices involved. Note: Simple audio

filters and or unbalanced to balanced transformers, used at the

installation site, are also useful in eliminating "noise" and cleaning

up the SMPTE signal.

Filename Already Exists

This is considered a non-fatal error and you will be given the

opportunity through the dialog box below to make the decision as

to how to handle this condition.

FTPing Font Files (.ttf)

When FTPing font files (.ttf) set FTP to binary files.

Insufficient Disk Space

A check for this condition will be performed after you confirm the

intent to copy files, but before the actual copying begins. This

check compares the total amount of space required to copy all

selected files against the available disk space on the internal

storage. A safety margin of 300 MB available disk space will have

to remain after the copy for this test to pass.

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 205 206

Sin comentarios

FOCUS Enhancements 3.2 Manual de usuario Pagina 178